In Fudge 101wecovered a brief introduction of what is fudge, the ingredients of fudge, and the technique of making fudge. Fudge 102 is aimed at the newbie who is going to try their hand at making fudge. Now it’s getting exciting.
How long does it take to make fudge:
- about 18 min to reach boiling
- about 40 minutes to reach soft ball stage
- 60 minutes to cool
- 28 minutes to beat in a KitchenAid (your time for this may vary)
- 4 hours to set
Tips for the fudge newb:
Check the weather. If it’s humid don’t make fudge today.
You don’tneeda candy thermometer, but the ball stage is difficult for a newb to judge correctly, and the window of time between under-cooked and over-cooked is razor-thin. Save yourself the tears and get a good, digital candy thermometer. I havethis Taylor thermometerwhich is available onAmazon.comfor $22., I picked mine up at the St. Lawrence Market and also use it for tempering chocolate.
Get everything ready before you turn on the stove. Line your pan with foil and grease it. Completely grease the pot you’ll cook the sugar in, right up to the edge. Grease the wooden spoon or beater blade.
Have a jug of cold water in the fridge, and a larger pan set on the counter to be the water bath.
Read your recipe thoroughly, make sure you understand when to stir and when not to. Understand at what point you add any extras like nuts or fruit (typically right before it’s ready to be poured into the pan).
Beware the recipe that tells you to chill the fudge to ensure it sets. Proper fudge will set after sitting at room temperature for about 4 hours.
Understand that cooking the fudge properly is the skirmish before the war. The real test of your mettle will occur when you beat the fudge, and learn to master the fine art of turning and pouring. And if it doesn’t work out it’s okay! Don’t give up.
What works for one person…
- some recipes insist on cream, others use milk
- some add the butter at the beginning, others add it when the vanilla is added
- some people use a wet pastry brush to wipe away sugar crystals
- some people only beat by hand, others use a hand mixer or stand mixer
Personally, I use 2% milk, becauseevery timeI made fudge with cream it failed. I add the butter at the beginning, and beat it using my KitchenAid. My fudge never turned out until I started using a water bath, and I am still mastering when to stop beating it.
Equipment:
- digital candy thermometer, remember to calibrate it
- heavy-bottom sauce pot, ideally with straight sides so you can clip thermometer onto it
- sturdy wooden spoons (avoid metal which conducts the insane heat right into your skin)
- hand mixer or stand mixer (unless you’re a masoch*st and you actually want to beat fudge by hand, in which case have at it)
- 8″ square pan + one bigger pan to serve asthe cold water bath
- tin foil
OK! I’m ready to get fudging!
Just one more thing! I talked earlier about when the thermometer hits “soft ball” (235°F to 240°F, or 112.78°C to 115.55°C) you should remove the pot from the heat immediately and place it in a cold water bath.
Not all fudge-makers use a cold bath, but I recommend it for this reason: supersaturated sugar is so hot, it continues to cook after you remove it from the heat (like taking something out of the microwave, it keeps getting hotter). If you are removing the fudge from the stove at the top of the soft ball range, which is no higher than240°F or 116°C , your fudge willcook itselfright past the optimum temperature and no wonder it’s not going to set.
Once it starts creeping up to the ideal range, I watch it like a hawk, and as soon as it’saboutto hit soft ball (it’s one or two tenths of a degree away), I take it off the stove and set it in the water bath pan. As soon as the temperature peaks I add the cold water so that way it can’t get past soft ball. Thetemperature will begin to drop and now you can’t exceed the soft ball stage. Make sense?
Let the pot sit undisturbed between 30-60 minutes, until temperature drops to 100°F or 37.77°C. Some people say you don’t need to go this low, but I’ve started aiming for this temperature after reading how cooler sugar crystals stay smaller (to avoid grainy fudge).
Then, andonly then, are you ready for the final confrontation.
FAQs
Let cool before beating
After being cooked, the sugar must crystallize again to create fudge. This stage will determine the size of the sugar crystals. The sugar should ideally form small crystals that are barely discernible on the tongue. To achieve this, let the mixture cool for 15 minutes before beating it.
What is the secret to good fudge? ›
Don't stir!
Once the fudge reaches soft-ball stage on the candy thermometer, remove from the heat and let the temperature drop to 110°F. Keep that spoon or spatula out of the pot until this happens. If you stir too early in the process, you'll make the sugar crystals too big and end up with grainy fudge.
Why is my 3 ingredient fudge not setting? ›
Why won't my 3 ingredient fudge set? This often happens when the condensed milk and chocolate chip mixture isn't hot enough to start. Everything must be completely melted before it is transferred to the pan to cool.
How long does fudge take to set? ›
Pour the fudge mixture into the prepared casserole dish and spread out in an even layer. Let the fudge rest at room temperature for 15 minutes before placing in the refrigerator, uncovered. Refrigerate until the fudge is firm, about 2-3 hours (or overnight), before slicing and serving.
What happens if you beat fudge too early? ›
Beating before cooling
This fudge was beaten immediately after cooking, while it was still very hot. Its crystals are so big that it has practically reverted back to a sugar state!
Do you stir fudge when it's boiling? ›
Avoid Stirring Once the Mixture Comes to a Simmer
Another key part of a successful fudge texture is when you stir the mixture. Stirring the sugar and milk during the initial stages of cooking allows the sugar to dissolve. However, once the mixture comes to a boil, it's time to put the spoon down.
Is evaporated milk or condensed milk better for fudge? ›
Evaporated milk doesn't have sugar added. The sweetened condended milk is needed as no extra sugar is added to the fudge. If evaporated milk were used then the fudge would not be sweet enough and also would still be too soft unless the fudge is frozen.
Can you reboil fudge that hasn't set? ›
How can you fix soft fudge? Put it in a microwave safe bowl that is large enough that it won't boil over. Reheat it to the boiling point and cook for about 3 more minutes. Then you can beat some powdered sugar into it if this doesn't make it set.
What is the best pan to make fudge in? ›
Saucepan: Choose a heavy, straight-sided metal saucepan that holds about twice the volume of your fudge recipe.
What is the secret to smooth fudge that is not gritty? ›
Once the sugar has dissolved and the mixture has come to a boil, do not stir it. If you do, the sugar can crystallize, giving your fudge a gritty texture. As you beat the fudge, pay attention to color and texture. Once the fudge loses its sheen and thickens, put down your spoon.
Options for what you can do with your unset fudge:
OPTION 1) Depending on how runny it is, you can either use it as a frosting for cakes, or a sauce for ice-cream. OPTION 2) Freeze it overnight. Cut it into squares. Cover each square thickly in melted chocolate, ensuring no part of the fudge is exposed.
Why is fudge so hard to make? ›
Making fudge can be a challenging endeavor, requiring precision and attention to detail to achieve the perfect texture and consistency. The process of making fudge involves a delicate balance of cooking, cooling, and beating, and the smallest mistake can result in fudge that is too soft or too hard.
What happens if you don't boil fudge long enough? ›
The amount of time you cook fudge directly affects its firmness. Too little time and the water won't evaporate, causing the fudge to be soft. Conversely, cook it too long and fudge won't contain enough water, making it hard with a dry, crumbly texture.
Do you set fudge in the fridge or room temp? ›
The ratio of chocolate to condensed milk needs to be just right, otherwise you might end up with fudge that is too soft or too hard. Do not freeze the fudge to set it. Best way is to just be patient for a couple hours and set it in the fridge. If your fudge hasn't set, then you've gone wrong somewhere else.
How to tell if fudge is ready without a thermometer? ›
Using a clean spoon, carefully take a little of the syrup and drop it into the bowl of cold water. Leave to cool for a moment then pick up the ball of syrup. If it's pliable, sticky and can be moulded in your fingers easily, it has reached the soft ball stage and the syrup can be used to make fudge and marzipan.
Can you overbeat fudge? ›
Beating the cooled batter is one of the crucial steps of fudge-making, but overbeating can turn fudge hard as a rock. Pay close attention to the change in appearance and only beat the fudge until it loses its glossy sheen.
How long does it take for fudge to thicken? ›
Turn off the heat and keep stirring for 5 minutes or until the mix starts to thicken a little. Pour into a prepared tin and sprinkle with the white chocolate. Swirl the chocolate through the mixture once using a spatula or the handle of a wooden spoon. Leave the fudge to set overnight.
How to get fudge to soft ball stage? ›
Stir the ingredients to dissolve the sugar until the mixture comes to a boil. If your recipe uses milk, stirring will keep the mixture from curdling. But once it reaches about 236–238 degrees F/113–114 degrees C (the "soft-ball" stage), do not stir it or even shake the pan.
